How to setup RFID - UHF setup  at GoDEX GX4000i Pro 

After instaling internal antenna and RFID modul start GoTool with RFID pre- set command.

Press next buttons:

1. RFID Profile Europe
2. Enable RFID Anetnna 
3. For shorter label then 70mm long start mode 0 calibration
   power and position
4. For Long label for example 150mm long you can try mode1 or mode 2
   which are quicker mode for longer label 

Then Start Golabel2 RFID and select RFID printer tool

With this tool customer can find position and power for RFID label - RFID Calibration button.

Then if customer want to check if calibration is good and not  to lost label he can press button
"Retry timer test" and customer can define with how many labels he wnat to make it.
For example with 10 labels or 40 labels. So on those labels nothing will be printed but it will be encoding testen.

At end to get results of "Retry timer test" customer need to press button "Getting retry timer test result"
where will be show errors during encode test - or no errors like on picture above.

At label setup cutomer can set to use current setup of printer for RFID power and position or to use the one that are set in label

For printing from database heer is one example. For example customer can write in one colum 24 characters 
and connect database to label.

Then at RFID command editor setup